NOTE · 2026-11-16

Zouzou first power-up, seven checks in order

The order I power up the maze robot after flashing it. Each check proves one part of the wiring before the next one depends on it.

  • zouzou
  • esp32
  • commissioning
  • 2 min read
Download the file
In this document
  1. Before the checks
  2. The seven checks
  3. Why the order matters
  4. You never need the gear ratio
  5. What is not covered here

Flash the firmware once, then everything is done from the phone. The robot makes its own Wi-Fi network and serves one page, so no app and no internet are needed. The seven checks below come from section 5 of the manual.

Warning. Set the buck converter to 5.0 V with a multimeter before connecting anything to it. Out of the bag they are often set to 12 V or more.

Before the checks#

SettingValue
BoardESP32 Dev Module, core esp32 3.x
Librariesnone
Sketchfirmware/zouzou_v3/zouzou_v3.ino
Remotejoin the robot's Wi-Fi, then open http://192.168.4.1

The seven checks#

  1. The F. At power-up the matrix shows a letter F for a second. If it is sideways or mirrored, change MATRIX_ROTATION and MATRIX_MIRROR in config.h until it reads correctly.
  2. Battery. The voltage at the top right of the remote should match a multimeter within 0.3 V. If it shows 11.1 V and never moves, the divider on pin 33 is not connected.
  3. Line sensors. In the Lab tab, slide a strip of tape under the row: each of the five bars rises in turn, left to right. A bar that stays flat is a wiring fault or a sensor mounted too high.
  4. Ultrasonic sensors. Hold a book in front of each sensor: the Left, Front and Right numbers follow in millimetres. A dash means no echo.
  5. Wheel test. Wheels off the ground, press Wheel test. Each wheel spins forward for a moment and the remote says what to flip in config.h if a wheel or an encoder runs backwards.
  6. The ruler. Press Zero the ruler, push the robot 500 mm along a ruler, and change Micrometres per tick until Driven reads 500. Then turn it one full turn by hand and change Track width until Turned reads 360.
  7. Two measurements with a real ruler. Enter Line sensors to axle. For wall mazes also Axle to front sensor and Side sensors ahead of axle. Then press Save tuning.

Why the order matters#

Each step relies on the one before it. The matrix proves the board boots and the 5 V rail is alive. The battery reading proves the divider, which the firmware needs to limit the motor voltage. Sensors come before motors because a robot that cannot see should not be allowed to drive.

You never need the gear ratio#

The starting value assumes a 1:50 gearbox and 34 mm wheels:

3.1416 x 34 mm / (7 pulses x 2 edges x 50) = 0.153 mm per tick

Step 6 replaces that guess with a measurement of the actual robot, so a different gearbox or wheel only changes one number in the Lab tab.

What is not covered here#

Gains and wall-maze constants are tuned after these checks, on the real maze. That part is in the Zouzou dossier and in section 11 of the manual.

IN 60 SECONDS

Elmehdi Essamit

I build complete systems, from the ESP32 sensor to the power-flow solver, and validate every result against a reference.

Profile
Engineering student, year 1 · EHTP
Looking for
Introductory internship · 1 to 2 months
Period
Summer 2027
Mobility
Morocco or abroad
Languages
Arabic · French · English
Download the CVessamit.elmehdi@proton.meLinkedInFull recruiter page

Search the portfolio