EXPERIMENT LOG
EXP-001 · RL / RLC comparison
Retrospective record of values reported in the 2026 TIPE.
In this document
Objective#
Compare peak efficiencies of non-resonant RL and resonant RLC configurations during a frequency sweep.
Configuration & equipment#
Inductive coupling bench, function generator, oscilloscope, and load. Full component values and settings must be taken from the original presentation before reproducing the experiment.
See the annotated benchControlled variables and traceability#
Archive: 2026 TIPE session. The exact experiment day is not recorded. For a repeat, hold geometry, load and excitation fixed during each sweep, then record any change between the RL and RLC configurations.
Data & result#
| Configuration | Reported peak efficiency | Frequency |
|---|---|---|
| Non-resonant coupling (RL) | 7.4% | Not specified for this peak |
| Resonant coupling (RLC) | 23% | 34 kHz |
These values compare the peaks of two configurations, not two measurements guaranteed to share the same frequency.
Source: TIPE presentation, slide 23Raw measurements are not available in the archive. No reconstructed measurement CSV is supplied.
Observation#
The reported resonant peak exceeds the non-resonant peak. This comparison alone cannot isolate every cause or establish uncertainty.
Record limitations#
This summary preserves the peaks on slide 23. It supplies neither a raw series nor a complete uncertainty budget, and does not establish that both peaks occurred at the same frequency.
Next action#
In a new experiment, retain every sweep point, instrument settings, repeated measurements, and measurement uncertainty.
Blank template for a future measurement